4 Programming
4-3
Digit 4 indicates/selects one of the following DLS connections:
4.2 DLS Programming
4.2.1 Local Programming with PC-Link
Follow the steps below in the sequence indicated.
1. Ensure front cover is removed and the system is powered up.
NOTE: PC-Link connections are “hot-swappable”. GPRS/Ethernet module connections are not 'hot-swappable' and the PC9155 should be
powered down before connecting or disconnecting this module.
2. For systems with a GS2065 or TL265GS module installed, disconnect the PC-link connector from the PC9155 module side first.
3. Initiate a DLS PC-link session on the DLS computer.
4. When the “Waiting for panel to connect” message is displayed on the DLS computer, connect the PC-link cable between the computer and
the header pins on the alarm system.
• Connecting the DLS PC to the alarm system automatically initiates a DLS session.
• If the DLS session is not automatically initiated, enter [
✱ ][8][Installer Code][499][Installer Code][499] to manually initiate PC-Link
(Refer to the DLS software help file for programming details).
5. Upon completion of the session, remove the PC-link cable from the alarm system, power down, and reconnect the cable for the GPRS/Ether-
net module (if installed).
4.2.2 Remote Programming via Telephone Line
Refer to section [401] DLS Downloading for setup details.
4.3 Installer Programming
Enter [][8][Installer Code].
The system prompts for a 3-digit programming section number (refer to Chapter 5 for programming details).
Openings & Closings - Sets Residential Dial Reporting Codes for all openings and closings
DLS/Installer Lead-in/out
Users CLOSINGS, Residential Dial Reporting Codes Section DLS Lead-in
1-8 51 52 53 54 55 56 57 58 [339] Section [347] Opt 4
9-16 61 62 63 64 65 66 67 68 [339] DLS Lead-out
40 99 FF FF FF FF XX XX XX [341] Section [347] Opt 5
Users OPENINGS, Residential Dial Reporting Codes Section Installer Lead-in
1-8 11 12 13 14 15 16 17 18 [342] Section [347] Opt 11
9-16 21 22 23 24 25 26 27 28 [342] Installer Lead-out
40 98 FF XX XX XX XX XX XX [344] Section [347] Opt 11
Enable Opening/Closings call directions for Phone 2
FF=disabled, XX=Not Used
[367]Opt 2 ON Enabled for Options 8 only
Option
Double Call
Sect [401] Opt 1
Call Back
Sect [401] Opt 3
User Call Up
Sect [401] Opt 4
#Rings
Sect [406]
1
000
2
008
3
008
4
008
i
After downloading a 2-way wireless key serial number to the PC9155, a button must be pressed on the wireless key before it
becomes operational.
Commentaires sur ces manuels