Alexor PC9155D-433 Guide d'installation télécharger pdf (Page 15)

2 Installation

2-7

2.4 Global Wireless Device Placement Test

2.5 Individual Wireless Device Placement Test

Wireless Device Placement

Perform the Wireless Device Placement testing on keypads, sounders and sensors only.

• This test is NOT required for wireless keys or pendants. Verify that pendants and Key FOBs operate within the desired operating

area by arming and disarming the sytem.

• Test each device multiple times to ensure a good placement.

• If a device tests BAD reposition the device and retest. Slight changes in placement can cause significant differences in signal

strength and range of the wireless device.

Step

• To enter individual Wireless Device Placement Test:

Press - for wireless zones

- for wireless keypads

- for wireless sirens

represents the new installer code programmed in

Installer’s programming to replace the 5555 default installer code.

Step

Place the wireless device in the indended mounting location.

Activate the device as described in the associated installation sheet.

• If the alarm system receives a STRONG signal the bell will sound once and ‘Location

is Good’ will be displayed on the LCD.

• If the alarm system receives a WEAK signal the bell will sound 3 times and ‘Location

is Bad’ will be displayed on the LCD.

• If the alarm system indicates no response, reposition wireless device and repeat

test.

Step

Repeat Step 2 for each device.

When placement testing is complete, press to exit Installer Programming.

Two-way wireless keys must be activated by pressing any key before they become functional.

To placement test a wireless keypad, press number keys 0-9.

To placement test a wireless siren, press the Test button, or tamper the device.

Wireless Device Placement

Placement testing can be performed on individual wireless devices. To configure the alarm system for individual placement test,

option [8] in section [804][900] must be turned off. Use the scroll keys or enter a 2 digit entry to select a specific keypad, zone or

siren depending on which placement test section is entered.

Step

• To enter individual Wireless Device Placement Test:

Press

- for wireless zones

- for wireless keypads

- for wireless sirens

represents the new installer code programmed in

Installer’s programming to replace the 5555 default installer code.

Enter Section

---

Select Device <>

for Test

Activate Device

Location is Good

Activate Device

Location is Bad

System is

Ready to Arm <>

Enter Section

---

Select Device <>

for Test

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 87 88

Commentaires sur ces manuels

Pas de commentaire

Alexor PC9155D-433 Guide d'installation Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Alexor PC9155D-433