Alexor WT8989 Manuel d'utilisateur télécharger pdf (Page 11)

10. Bypassing Zones

Use the zone bypassing feature when you need access to a protected area while the system is armed/

set, or when a zone is temporarily out of service but you need to arm/set the system. Bypassed zones

will not be able to sound an alarm. As a result, bypassing zones reduces the level of security. If you

are bypassing a zone because it is not working, call a service technician immediately so that the prob-

lem can be resolved and your system returned to proper working order. Ensure that no zones are

unintentionally bypassed when arming/setting your system. Zones cannot be bypassed once the sys-

tem is armed/set. Bypassed zones (except for 24-hr zones) are automatically cancelled each time the

system is disarmed and must be bypassed again, if required, before the next arming.

With the system disarmed/unset:

Activating all Bypassed Zones

To remove bypass (all zones):

1. Press [

,][1], then your access code.

2. Press [0][0].

3. To exit bypassing mode and return to the Ready state, press [#].

Recalling Bypassed Zones

To recall the last set of bypassed zones:

1. Press [

,][1], then your access code.

2. Press [9][9].

3. To exit bypassing mode and return to the Ready state, press [#].

10.1 Bypass Group

A Bypass Group is a selection of zones programmed into the system. If you bypass a group of zones

on a regular basis, you can program them into a Bypass Group, so that you do not have to bypass

each zone individually. Note that only one Bypass Group can be programmed at a time.

To program a Bypass Group:

1. Press [,][1], then enter your access code.

2. Enter the 2-digit numbers (01-64) of the zones to be included in the Bypass Group or use the

[<][>] buttons to find the zone to include in the Bypass Group, then press [

,] to select the zone.

3. To save the selected zone into the group, press [9][5].

4. To exit bypassing mode and return to the Ready state, press [#].

NOTE: If an access code is required to enter bypassing, only the master code and codes with Supervisory

enabled can set the Bypass Group.

To select a Bypass Group when arming/setting the system:

1. Press [

,][1], then your access code.

2. Press [9][1]. The next time the system is armed/set, the zones in this group will be bypassed.

3. To exit bypassing mode and return to the Ready state, press [#].

NOTE: A Bypass Group is only recalled if the system is armed/disarmed (set/unset) after programming the

Bypass Group.

1. Press [,] to enter the function menu. The keypad will display the

screen on the right.

2. Press [1] or [

,].

3. If your system is programmed to require access codes the screen on the

right will be displayed. Enter your 4-digit access code.

4. Scroll to the desired zone number using the [<][>] keys, then press [

to select the zone or directly enter the 2-digit number of the zone you

wish to bypass (e.g., 0 5 for zone 5).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Alexor WT8989 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Alexor WT8989